Sony MVS-8000 User Manual page 194

Program outputs 1 to 4, preview output, key preview outputs 1 and 2,
clean output.
Further, you can select the program background from Clean or Utility2,
and change the combination of signals from which it is configured. (PGM
Config)
– DSK mode: Treat P/P as four DSKs, with no background transitions. Of
backgrounds 1 to 4, set one to configure the program output. (PGM
Config) The signals which can be selected as the background are limited
to Out1 to 6 from M/E-1.
Regardless of the current M/E Config mode, you can set the key preview
configuration to be video mode or key mode. In key mode, select whether
to link the key state to the on/off operation, or have it always on. (K-PVW
Config)
• User 1 to 8 Config: Assign the User regions, being color backgrounds 1 and
2, AUX1 to 48, monitor 1 to 8, frame memory 1 to 8, and color correctors 1
and 2, to any of User1 to User8.
• Logical M/E Assign: Make settings for handling PGM/PST hardware
logically as an M/E.
• DME Config: Set the DME channel assignments used on the individual
M/E and PGM/PST banks.
• Side Flags: Make settings relating to the side flag function (inserting a
selected image on both sides of a 4:3 image).
Input signal settings (Input)
• Input Phase Adjust: Carry out phase adjustment for each primary input.
• Through Mode: Set through mode for the input side. This applies only to
the primary inputs, and can be set independently for each primary input.
• Video Process: Switch video processing on or off for each input signal, and
adjust the brightness, hue and so forth.
• Matte Illeg. Color Limit: Switch the illegal limiter on or off for the signal
generated by the switcher internal matte generator.
• FC Adjust (for MVS-8000G only): Set the format converter inputs.
Output signal settings (Output)
• Output Assign: Assign the signals output from the Output1 to 48 ports.
• Video Clip: Adjust the clip levels (White Clip, Dark Clip, and Chroma Clip)
for the output signals from each of the Output1 to 48 ports.
• V Blank: Adjust the vertical blanking width for the output signals from each
of the Output1 to 48 ports. The setting is the number of scan lines from the
reference blanking position of field 1 for the particular format which should
be masked.
• Through Mode: Enable or disable through mode. Through mode can be
enabled for AUX1 to 48 outputs, M/E and PGM/PST program outputs, and
clean output.
193
Setup