Sony MVS-8000 User Manual page 343

6
To select a video signal assigned to a cross-point button
By selecting the key source bus with an auxiliary bus control block AUX
delegation button, and pressing the cross-point button, it is possible to select
the video signal assigned to the cross-point button.
(If you press the cross-point button with holding down [KEY], the key signal
assigned to the cross-point button.)
Note
In the above operation, the following settings must have been made.
• Assigning the key source bus to an AUX delegation button
• Setting the [KEY] button operating mode
Carrying out a color mix for key fill
When [Matte] is selected for key fill, you can combine color 1 and color 2. For
the combination, you can use not only a key wipe generator pattern, but also
the dedicated pattern for key edge color mix.
342
Key Setting Operations Using Menus
When [Split] was selected in step 5, hold down the [KEY1] button and
press the appropriate button in the key row to select the key source signal.
To select the video signal assigned to the button, turn off the [KEY] button
in the AUX bus control block, and to select the key signal, turn on the
[KEY] button before pressing the button in the key row.
Notes
• Carrying out a [KEY] button operation in the AUX bus control block
requires the [KEY] button operating mode (Key Source Bus Select
Mode) to be set. With the factory default setting (Key), the [KEY] button
is always off, and it is only possible to select a key signal assigned to a
button as the key source signal.
For details, see "Operation Settings (Operation Menu)" in Chapter 16
(Volume 2).
On the MVS-8000, the video signal selection operation is not supported.
• When [Split] is selected, the key memory function (see page 52) is
disabled.
For details, see "Auxiliary Bus Control Block Settings (Aux Assign Menu)"
in Chapter 16 (Volume 2).
For details, see "Operation Settings (Operation Menu)" in Chapter 16
(Volume 2).
This operation is not supported on the MVS-8000.