Sony MVS-8000 User Manual page 385

Defocusing
1
2
Note
If defocus is enabled, and in the <Mosaic/Defocus Mode> group you select
Video/Key, then the crop and mask are disabled.
Applying a mask to mosaic or defocus
1
2
3
4
5
384
Resizer
In the M/E-1 >Key1 >Processed Key >Enhanced Effect menu, press
[Defocus], turning it on.
Set the parameters.
This operation is the same as the defocusing setting when using the DME
with the DME dedicated interface. However, <Mosaic/Defocus Mode>
appears in place of <Defocus Mode>. For more details, see "Defocus
Settings" in Chapter 11 (Volume 2).
In the M/E-1 >Key1 >Processed Key >Enhanced Effect menu, press [Dual
Rszr Effect], turning it on.
Press [Mask], turning it on.
This enables the mask function.
To make the mask settings, continue with steps 3 and following.
Press [Mask Menu].
The Mask menu appears.
In the <Mask Source> group, select either of [Box] and [Circle].
Box: Use a box pattern as the mask signal.
Circle: Use a circle pattern as the mask signal.
Set the parameters.
The valid ranges of the parameter values depend on the combination of
signal format (SD/HD) and aspect ratio (4:3/16:9) selected in the system,
as follows.
The parameters are the same as for drop shadow. For more details, see
"Applying a drop shadow" (page 381), except that knobs 3 and 5 are as
follows.