Xantrex Powerpack 300 Owner's Manual page 52

Table 5-1 Troubleshooting reference
Problem
The engine
being jump-
started will not
start.
The jump-start
clamps
measure zero
volts.
The
compressor
runs, but won't
inflate.
The
compressor
runs slowly.
Possible Cause
XPower Powerpack
battery is not fully
charged.
The engine condition is
poor.
The engine start capacity
exceeds the XPower
Powerpack jump-start
capability.
Jump-start power switch is
.
OFF
XPower Powerpack
battery needs to be
recharged.
The valve connector may
not be securely placed on
the valve stem.
The item being inflated
may have a leak.
The compressor may have
overheated from excessive
use.
Battery voltage is too low.
Troubleshooting Reference
Solution
Recharge the XPower
Powerpack battery.
Have the engine serviced.
Use a higher power XPower
Powerpack.
Turn the jump-start power
switch .
ON
Make sure the valve connector is
securely placed on the valve
stem before closing the thumb
latch.
Make sure the item being
inflated doesn't have a leak.
Check the compressor hose for
any breaks or leaks.
Turn off the compressor and let it
cool down.
Check the condition of the
internal battery. The battery may
need to be recharged or replaced.
39