Recharging With The Dc Charging Cable - Xantrex Powerpack 300 Owner's Manual

Recharging the XPower Powerpack Battery

Recharging with the DC Charging Cable

Using the DC charging cable, the XPower Powerpack can be
recharged while you drive your vehicle.
Important: Although the charge regulation circuitry in the
XPower Powerpack does not operate with this charging method,
most vehicle voltage regulators will ensure that the XPower
Powerpack is not overcharged.
Note
XPower Powerpack is recharged using the DC charging cable.
WARNING: Fire and explosion hazard
Do not use this recharging method if your vehicle has abnormally
high voltage electrical systems that operate above 15 V DC. This
may lead to accumulations of hydrogen, causing exposure to fire
and explosion hazard.
CAUTION
Do not operate AC or DC appliances while the XPower Powerpack
is being recharged with the DC charging cable from your vehicle.
To recharge the XPower Powerpack while you drive using
the DC charging cable:
1. While the vehicle engine is running, plug one end of the
2. Plug the opposite end of the DC charging cable into the
3. Once the XPower Powerpack is fully charged or if your
30
:
The Battery Status LED will not illuminate when the
DC charging cable into a DC power outlet on the XPower
Powerpack.
vehicle's lighter socket or 12 V accessory outlet.
vehicle's engine is not running, disconnect the DC
charging cable from both sockets.
Most of the XPower Powerpack's capacity will be
restored in 2
½
hours while the vehicle engine is running.