MANUAL WALL CONTROL OPERATION
OPERATING YOUR MANUAL WALL CONTROL
The Manual Wall Control requires you to manually control Pump (and Pre-Wet cycle) operations, fan operation
and the fan speed� On days of high humidity for ventilation the fan may be operated without operating the pump�
To run the Cooler
1�
Push the ON/OFF button (1) to turn the controller ON, the Power indicator (2) will illuminate.
2�
Slide the COOL switch (3) to the ON position� This will operate the pump�
After sliding the COOL switch (3) ON allow 5–10 minutes to Pre-Wet the filter pads before sliding
the FAN switch (4) ON. Doing this will provide for the maximum cooling immediately when the fan
is switched ON.
IMPORTANT
3�
Slide the FAN switch (4) to the ON position�
4�
Rotate the FAN SPEED dial (5) to set the desired airflow level.
To turn OFF
1�
Push the ON/OFF button (1) to turn the controller OFF, the Power indicator (2) will go out.
To tun the Fan for ventilation
1�
If already cooling, slide the COOL switch (3) to the OFF position, this will turn off the pump and use the fan
for ventilation only�
OR
1�
When OFF, push the ON/OFF button (1) to turn the controller ON, the Power indicator (2) will illuminate.
2�
Slide the Fan switch (4) to the ON position�
3�
Rotate the Fan Speed dial (5) to set the desired airflow level.
On days of high humidity the fan may be operated without the pump. For ventilation only, turn the
Cool switch OFF which turns the pump OFF.
NOTE
Brivis
1
4
3
18
2
5
Evap AC OM