Coded Messages; Message Repeating; Service Notification Message; Resetting - Rinnai Brivis Contour Series Operation Manual

Press either the ON/OFF button (1) or the PROG button (5)� The Brivis Networker remembers the last setting
and the next time you select the Timer it will go to that same setting.
11
10
13
12
4

CODED MESSAGES

While the Brivis Networker is operating your system, it is also monitoring and controlling every aspect of the
system's performance. If anything unusual occurs, the Brivis Networker will display an error message.
•
A message (23) stating "Cooler Fault - E01 Code #?? For assistance call 1300 555 545" will scroll across the
top of the screen� Note that the message will vary depending on the problem�
•
Whenever such a message appears, it is a good idea to write it down before doing anything else. This code
contains information that will enable Brivis to deal quickly and easily with anything that requires their attention�
With many of them you will be asked to contact Brivis Service and pass on the message, the model and the
type of appliance�

MESSAGE REPEATING

Push the FUNCTION button (2) then Key 1 (14) immediately after to repeat a message.
If no message repeats it means either the button combination was incorrect or the event has
passed. Typical messages displayed advise of some appliance operations such as - "Pre-Wetting
cooler pads - Please Wait!".
NOTE

SERVICE NOTIFICATION MESSAGE

When the operating hours logged for an appliance reach a predetermined duration, the spanner symbol
flashes once per second on the networker and a message displays, such as:
Fan run hours indicate it is time for a service call - For assistance call 1300 555 545
A service call may be booked�

RESETTING

If something has interrupted the units operation, the word Reset (26) may appear beside Key 4 (17) while a
message is scrolling. Press Key 4 (17) to re-start the Cooler.
If the Cooler does not resume normal operation, or the error message re-appears, contact Brivis Service.
If the Cooler is still operating but the Brivis Networker is showing an error message try pushing the Key 4 (17) to
clear the fault� If the fault persists contact Brivis Service�
If the Cooler is not operating and any other error message appears, contact Brivis Service.
Brivis
NETWORKER WALL CONTROL OPERATION
9
1
2
6
5
3
7
13
14
15
16
17
18
Evap AC OM