Manual Operation; Getting Started; Fan And Pump; Fan Only - Rinnai Brivis Contour Series Operation Manual

MANUAL OPERATION

Manual operation requires you to manually control the fan, its speed, and the pump.

GETTING STARTED

Begin by pressing the ON/OFF key to turn the Cooler on� For Manual operation the AUTO light must not be
illuminated�
Push the MODE key to cycle through the cooler's operating modes�

FAN AND PUMP

This is indicated by the illuminated Fan and Pump lights. The screen will then display a number, which indicates
the cooler fan speed�
Push the UP and DOWN keys to raise and lower the cooler's fan speed�
The fan light will flash during the Pre-Wet period.
NOTE

FAN ONLY

This is indicated by the illuminated FAN light. The screen will then display a number, which indicates the cooler's
fan speed�
Push the UP and DOWN keys to raise and lower the cooler's fan speed�
On days of high humidity the fan may be operated without the pump. For ventilation only, operate
the cooler in this mode.
NOTE

PUMP ONLY

This is indicated by the illuminated PUMP light. Only the pump will be running in this mode, and no air will be
circulating�

USING THE TIMER

This wall control has a timer function that can delay the operation of the ON/OFF key. If the cooler is operating,
you can pre-set the timer for the cooler to turn Off. If the cooler is off you can pre-set the timer for the cooler to turn
On. The timer is set in 1-hour increments, ranging from 1 to 12 hours. When setting the timer to turn the cooler on,
the wall control returns to the settings it had when it last operated. To check or adjust these settings turn the wall
control on, make any adjustments if necessary, then turn the wall control off and set the Timer. When setting the
timer to turn the cooler off, have the cooler running at your desired settings and set the timer.

SETTING THE TIMER

•
Press the TIMER key to enter the timer setting mode. The timer light will now be flashing and the screen will
display a number�
•
Push the UP and DOWN keys to set the delay in hours. The timer delay can only be adjusted while the timer
light is flashing.
•
To cancel the timer push the TIMER key twice or push the ON/OFF key�
•
After the timer has been set, leave the controller for five seconds until the timer light stops flashing.
Brivis
PROGRAMMABLE CONTROL OPERATION
17 Evap AC OM