Setting The Time & Day; Setting The Cooler To Turn Itself On; Setting The Cooler To Turn Itself Off; Checking Your Timer Settings - Rinnai Brivis Contour Series Operation Manual

NETWORKER WALL CONTROL OPERATION
If the pump is going to be used, adequate ventilation (openings) need to be provided to prevent
condensation build up.
CAUTION
SETTING THE TIME & DAY
1� Ensure the Networker is turned OFF using the ON/OFF button (1)�
2� Press Key 5 (18 - Clock) and the screen will display the message "Clock setting mode", and then the Digital
Clock (19) will flash.
3� Use the Rotary Dial (7) to select the right time�
4� Press Key 1 (14 -Day) until the correct day appears e.g. Mon (20).
5� Press Key 5 (18 - Clock) again to save the changes.
If you have dual Brivis Networkers installed, only the Master control has the ability to set the
clock time. The Master control can be identified by the word "clock" beside Key 5 (18), while the
Brivis Networkers are in the off position.
NOTE

SETTING THE COOLER TO TURN ITSELF ON

1� Press the PROG button (5) and the display will flash ON TIME and the word PROGRAM.
2� Use the Rotary Dial (7) to set the ON TIME (i�e� the time you want the Cooler to come ON)�
3� You can change the settings the cooler will run at here�
When in Manual mode, use the Rotary Dial (7) to adjust the fan speed and press Key 2 (15) to turn the pump
ON or OFF. When in Auto mode, use the Rotary Dial (7) to adjust the comfort level.
4� Press Key 3 (16 - On Time / Off Time) to activate the Timer.
5� Press the PROG button (5) to exit and save your setting.
The LCD screen (13) displayed On Time (21) to show that an On timer is set. To cancel the Timer
press Key 3 (16).
NOTE

SETTING THE COOLER TO TURN ITSELF OFF

1� Ensure the cooler is turned ON�
2� Press the PROG button (5) and the display will flash OFF TIME and the word PROGRAM.
3� Use the Rotary Dial (7) to set the OFF TIME (i�e� the time you want the Cooler to turn OFF)�
4� Press Key 3 (16 - On Time / Off Time) to activate the Timer.
5� Press the PROG (5) button to exit and save your setting.
The LCD screen (13) displayed Off Time (22) to show that an Off timer is set. To cancel the Timer
press Key 3 (16).
NOTE

CHECKING YOUR TIMER SETTINGS

Once Timer settings are made you can review or cancel them in a number of methods:
The LCD screen (13) displays On Time (21) and or Off Time (22) to show that these timers have been pre-set.
If you want to check what you've done
Press the PROG button (5) and the pre-set time will flash. You can now make adjustments to your settings if
required�
If you change your mind and want to cancel the function
Press the Key 3 (16 - On Time / Off Time) and this will cancel the function.
To exit this setting program
Brivis 12 Evap AC OM