Operation Manual Split Type Wall Mounted Air Conditioner Models: RINV25RB / RINV35RB / RINV52RB / RINV70RB This appliance shall be installed in accordance with: • Manufacturer’s Installation Instructions • Current AS/NZS 3000 • Local Regulations and Municipal Building Codes including local OH&S requirements This appliance must be installed, maintained and removed by an Authorised Person.
Page 2
This page is intentionally blank Rinnai Split AC OM...
Care & Maintenance General Maintenance ��������������������������������������������������������������������������������������������������������������������������������������� 14 Cleaning the air filter ���������������������������������������������������������������������������������������������������������������������������������������� 14 Save A Service Call ������������������������������������������������������������������������������������������������������������������������������������������ 15 When to Call for Service ����������������������������������������������������������������������������������������������������������������������������������� 15 Warranty Installation Record Installer Details ������������������������������������������������������������������������������������������������������������������������������������������������� 19 System Details ������������������������������������������������������������������������������������������������������������������������������������������������� 19 Contacts Rinnai Split AC OM...
The table below indicates the temperature ranges the air conditioner can be operated within. MINIMUM MAXIMUM MODE TEMPERATURE SOURCE OPERATION OPERATION TEMPERATURE TEMPERATURE Adjustable inside temperature 16°C 32°C Cooling / Heating Ambient outside temperature -12°C 47°C Rinnai Split AC OM...
Page 5
DO NOT mix the batteries for the remote control with other types of batteries or mix new batteries with used batteries� Failure to do so may result in product failure� STOP using the remote control if there is a battery fluid leak. Rinnai Split AC OM...
The remote control may operate other electronic devices if pointed towards them. Make sure to point the remote control towards the signal receiver of the air conditioner. NOTE For proper operation, use a soft cloth to clean the signal transmitter LED and the receiver window. Rinnai Split AC OM...
Turns indoor temperature display ON / OFF. 16� LCD screen Displays settings and operation modes� 17� Wireless Transmitter LED *Not all functions are supported by all the models. Refer to Remote Control Operation for details. NOTE Rinnai Split AC OM...
SLEEP iClean HEALTH iFavor Select “AUTO” if you wish the fan speed to be adjusted automatically by the Anti - FUNGAS DISPLAY LOCK appliance� AUTO fan speed selection is not available when using the FAN ONLY mode. NOTE Rinnai Split AC OM...
"SET" is shown on the LCD screen and the temperature digits display the current set temperature� The "SET" temperature display is the default display for the remote control and will be reset when the controller is turned off and on. NOTE Rinnai Split AC OM...
Anti - FUNGAS DISPLAY LOCK 1 through 3. NOTE Altering any of the settings while in “FAV” mode will return the appliance to manual operation. Rinnai Split AC OM...
SWING in conjunction with SLEEP mode. SLEEP iClean HEALTH iFavor NOTE Anti - FUNGAS DISPLAY LOCK 4� Pressing the “SLEEP” button again will cancel sleep mode, "SLEEP" will no longer be shown on the LCD screen. Rinnai Split AC OM...
1� Press the “DISPLAY” once, “DISPLAY” is no longer shown on the LCD screen. 2� The large digital SET temperature display is de-activated� Only the set temperature can be displayed via the large temperature display. NOTE Rinnai Split AC OM...
When the power is restored the system will restart automatically using the same settings as those that were set before the power outage. After power restoration, the automatic restart cycle will take approximately 5 minutes. DO NOT adjust setting during the restart cycle period. NOTE Rinnai Split AC OM...
Ensure to re-insert the filter securely after cleaning, observing the same orientation as when removed. Failure to clean the filters regularly can cause condensation to form and drip from the indoor unit when operated in cooling mode during humid conditions. NOTE If you need more filters, please contact Rinnai. Rinnai Split AC OM...
WHEN TO CALL FOR SERVICE SYMPTOM CAUSE There is a burning smell and a strange Turn off the air conditioner, and contact Rinnai. sound coming from the unit� Water leaks from the indoor unit even when the humidity level is low.
Rinnai Australia Pty Ltd 1� WHAT IS COVERED BY THIS WARRANTY? We warrant that your Rinnai Product purchased in Australia is free from defects in material and workmanship, subject to the terms and conditions contained in this document� 2� WARRANTY PERIOD...
Page 17
(a) This warranty applies to products which are manufactured on or after the date of publication of this warranty but before the next date of publication of this warranty. Please contact Rinnai’s Technical and Spare Parts department for further information about the warranty booklet publication dates.
Page 18
No warranties except those implied and that by law cannot be excluded are given by Rinnai in respect of Goods supplied. Where it is lawful to do so, the liability of Rinnai for a breach of a condition or warranty is limited to the repair or replacement of the Goods, the supply of equivalent Goods, the payment of the cost of repairing or replacing the Goods or acquiring equivalent Goods as determined by Rinnai.
Braeside, Victoria 3195 For further information visit: www.rinnai.com.au Rinnai has a Service and Spare Parts network with personnel who are fully trained and equipped to give the best service on your Rinnai appliance. If your appliance requires service, please call our National Help Line. Rinnai recommends that this appliance be serviced every 1 years.