Manual Operation; Using The Timer - Rinnai Brivis Contour Series Operation Manual

MANUAL OPERATION

Manual operation enables you to control the fan, its speed, and the pump manually.
11
10
13
To run the Cooler in Manual mode, just follow these steps:
1� Turn the Brivis Networker on using the ON/OFF button (1)�
2� Press the Auto button (6) until "MANUAL" appears on the screen.
3� Press Key 1 (14) to turn the fan on (if the fan symbol (10) is not already on the screen)�
4� Press Key 2 (15) to turn the pump on (if the water droplet symbols (9) are not on the screen)�
5� Rotate the Rotary dial (7) to set the fan speed level you desire (up to increase the fan speed and down to
decrease the fan speed)� The set fan speed (11) is displayed on the LCD screen (13)� The message "Pre-
Wetting cooler pads – Please Wait!" will scroll across the display. It will take approximately 8 minutes for
the unit to complete the pre-wet before the fan will turn on�
On days of high humidity the fan may be operated without the pump. To turn the pump OFF press
Key 2 (15) and the water droplets (9) will disappear. The next time you return to Manual these
steps will not be necessary because the Brivis Networker remembers your previous settings.
NOTE

USING THE TIMER

When the Cooler is operating, you can pre-set a time for the Timer to turn the Cooler OFF. Also, when the Cooler
is turned OFF, you can select a time for the Timer to turn it ON automatically. So if you are out for the day you can
set the Cooler to come on and cool the house before you return. Before using the timer function you need to firstly
set the time and day�
19
20
13
Brivis
NETWORKER WALL CONTROL OPERATION
1
21
22
6
13
5
7
11
9
1
14
15
6
7
14
15
16
17
18
Evap AC OM