Zoning; Dual Brivis Networker Operation; Batteries - Rinnai Brivis Contour Series Operation Manual

11
10
13
12
4

ZONING

Some systems may include multiple Coolers with each operating in a different zone area. Zone keys (28) will
appear on the screen and these will have been set up and explained by the installer where required.
These zones can be operated in either "Manual" or "Auto" modes using the Zone keys - Keys 4 & 5 (17 &18).
Two Zone keys will appear if you have three or four zones and only one Zone key will appear if you have one or
two�

DUAL BRIVIS NETWORKER OPERATION

It is possible to have two Brivis Networkers connected to the system� The two Brivis Networkers will operate
together, one will be configured as a Master and the other as a Slave, and the settings for the Cooler will be
common on both controllers. The benefit of having two controllers is the convenience of making adjustments to the
Cooler settings at either location�
When an adjustment is made on one of the Brivis Networkers it is immediately reflected on the other Brivis
Networker�
Likewise locking one of the Brivis Networkers also locks the other Brivis Networker� The system can be unlocked
at either Brivis Networker�
In Auto mode, only the Master Brivis Networker will sense the comfort level within the house.
Only the Master Brivis Networker has the ability to set the clock time. Look for the word Clock (30)
NOTE
beside Key 5 (18), while both the Brivis Networkers are in the off position.

BATTERIES

The Brivis Networker requires no batteries. If the Brivis Networker has no screen, check your 240 volt power
supply (at the Cooler) or check the thermostat cable�
Brivis
30
NETWORKER WALL CONTROL OPERATION
9
1
2
6
5
28
3
29
7
15
Please note: This
picture displays the
lid closed. To reveal
more keys flip down
the lid from the top
18 right hand corner.
Evap AC OM
14
15
16
17
18