7�6 Setting Up Multiple Coolers On The Network - Rinnai brivis Contour Series Installation Manual

Table of Contents

Advertisement

7. NETWORK CONNECTION
7.6 SETTING UP MULTIPLE COOLERS ON THE NETWORK
To ensure each Cooler is configured correctly to the Brivis Networker see the instructions below and refer to the 
Brivis Networker Advanced Programming Manual No� 400 (Available on request from Brivis Customer Service)�
As the Brivis Networker is polarity sensitive when more than one Cooler is installed on a Brivis Networker all the
Coolers should be wired in parallel (see diagrams below)�
To ensure each Cooler is configured correctly to the Brivis Networker, each Cooler MUST BE:
Given a different specific identification number, starting at No. 1. 
Designated to a zone (refer to the Brivis Networker Advanced Programming Manual No� 404)�
Each Cooler comes with the ID number set at number 1. To give it a new number, first complete the installation 
and wiring of all the units, as described previously and follow the instructions on the next page� (Changing an
Identification Number)
Cooler No�1
Cooler No�2
Cooler No�3
Typical Brivis Advance, Brivis Promina & Brivis Contour
Brivis
Brivis Networker
Cooler No�1
Cooler No�2
Cooler No�3
Typical Brivis AD Application
16
Brivis Networker
Evap AC IM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents