Table of Contents
Advertisement
8.3 Cleaning the Optics System
8.3.1 Removing the Mirrors
We recommend that you check the mirrors once or twice a week to see if they require cleaning.
If any debris or smoke residue is present, use the following steps to clean them.
NOTE
•
Mirrors should be removed for cleaning one at a time to avoid beam misalignment after placing
them back to the lens holders.
•
Refer to section 8.3.2 on how to clean the mirrors.
The following section will illustrate the location of the four mirrors found on this machine for cleaning.
Mirror 1
Mirror #1 is located inside the bottom left access door panel of this machine.
1)
Use a #2 Phillips Screwdriver to open the access panel located on the bottom left side of this machine.
2)
Open the slot cover on the bottom left side of this machine
3) Loosen the thumbscrew and remove the black dust cover in front of laser tube.
204
Advertisement
Table of Contents
