Table of Contents
Advertisement
Extend (Paper Page) [DEFAULT SETTING: Unselected]
If you are processing a very large area requiring the maximum work table area, you will want to enable this
mode. Enabling this mode will extend the LV-290 maximum work area to 29" x 18" (740 mm x 460 mm) from
the default 25.197" x 18.110" (640 mm x 460 mm). This function is enabled at the expense of some quality
loss, usually on the left and right edges of your full-size engraving. Usually the quality loss is minimal and may
not be apparent, depending on your design.
NOTE
With the Extend function enabled, the following functions are disabled: 3D mode (Options Page),
Stamp Mode (Options Page), SmartACT (Options Page), Disable Skip White (Advanced), Auto Focus
(Pen Page), and Rotary Fixture (Paper Page).
Rotary Fixture (Paper Page) [DEFAULT SETTING: Unselected]
NOTE
This option is only to be used with the Rotary Attachment optional accessory properly set up. For
instructions on how to set up the Rotary Attachment, please refer to Chapter VII of this manual.
You will need to select this option when processing a job with the optional rotary attachment system to
engrave on round or cylindrical objects. When you have your material and rotary attachment properly set up:
1)
Check the Rotary Fixture function and notice the change in the Paper Size fields under Paper Size, the X
value represents the length of your work piece. Enter the length of your work piece in this field.
2)
Under Paper Size, the Diameter value represents the diameter of your working piece (at the position you
wish to engrave). Enter the diameter of your work piece in this field. Again, remember the proper
diameter value would be the diameter location, at the point of engraving on your work piece.
3)
Under Rotary Parameter, the Offset value represents distance from the open end of your work piece to
the base of the padded rubber wheel. This value will be displayed on the LCD panel. Enter the proper
offset value in this field.
127
Advertisement
Table of Contents
