Table of Contents
Advertisement
Decal Cutting: this function is developing to reduce material weeding job after laser cutting for multiple
layers adhesive materials, such as lettering vinyl, heat transfer film, and twill film. This function allows
allocating different parameters for corresponding decal layer numbers to do die cut (cut through media)
for the unwanted parts, and kiss-cut (half cut) for the kept material parts, after the laser cutting, users can
just peel off the materials to get rid of waste parts.
Enhanced Vector Mode (Advanced Page) [DEFAULT SETTING: Unselected]
This setting allows you to improve the cutting quality at the expense of speed. Your engraving speed will be
dropped by 50%, to maximize the cutting power. We recommend that you enable this function when cutting
thicker materials.
Decal layer No. 2:
Die cutting pen (Cut through)
Decal layer No.1:
Kiss-cutting pen (half cut)
122
Advertisement
Table of Contents
