16) Click "Execute" of Output window to process job.
17) If there is an error with the placement, SmartCONTROL
"Pattern Match Failure" message will pop up, press "OK "button to continue.
18) Move the carriage with red beam to the failed mark.
19) Click "Execute" again, SmartCONTROL
job.
NOTE
If the object placement angle is too large, SmartCONTROLTM Vision may not source the marks.
Repeat Step 17 ~ Step 19 operation.
Vision may not find the marks correctly.
TM
TM
Vision will automatically calibrate the position and continue the
165