Attaching The Vacuum-Adapter For Chip Cleaning - Roland EGX-30A User Manual

3-4 Setting Cutting Conditions

Attaching the Vacuum-adapter for Chip Cleaning

WARNING
WARNING
WARNING
The vacuum-adapter included with the EGX-30A can be attached to an ordinary household vacuum cleaner to remove cut-
ting chips during operation.
Before Using the Vacuum-adapter, Be Sure to Verify the Following Points
 Use a vacuum cleaner that allows adjustment of the suction force and is equipped with an overload protector.
To prevent fire or explosion, carefully check the specifications of your vacuum cleaner before use, including contacting
the manufacturer if necessary.
 Be sure to use a vacuum-cleaner hose having a diameter that allows connection with the vacuum-adapter.
The diameter of the vacuum-adapter is 32 millimeter (1.3 in.).
32 mm (1-5/16 in.)
30 cm (12 in.) or more
When the fitting diameters do not match or when the vacuum duct cannot be inserted into the suction
opening of the vacuum cleaner, use strong commercial tape (cloth or electrical) to join the fittings.
36
Chapter 3 Getting Ready for and Performing Cutting
Exercise caution to prevent fire or dust explosion.
Taking up fine cuttings using an ordinary vacuum cleaner may cause danger of
fire or explosion. Check with the manufacturer of the vacuum cleaner. When the
safety of use cannot be determined, never use the vacuum-adapter and a vacuum
cleaner.
Make the connection while exercising care not to touch the tip of the cutter.
Contact with the blade may cause injury.
Never touch the tool carriage immediately after cutting.
Doing so may cause burns.
Hose