Table of Contents
Advertisement
4.1 Machine Setup
4.1.1 Powering Up the Machine
Make sure both the LV-180 and computer are turned off before connecting either to a power source.
1)
Connect the male end of the power cord to a quality surge protector and then connect the surge
protector into a properly grounded outlet.
2)
Do the same for the computer system.
3)
Connect the air compressor and external air extraction system to the laser machine before powering up.
The connection and setup of air compressor and air extraction system refer to Chapter 7 for details.
4)
Connect the female end of the power cord to the machine's power cable inlet located on the right side of
machine.
NOTE
The LV-290 has been designed to automatically switch from 100-240 VAC.
4.1.2 Connecting the Computer
The LV-290 can communicate with a computer through a USB Port or LAN Port connection interface. Regardless of
the connection method chosen, you will need to connect the respective connection cable from the LV-290 to your
computer.
4.1.2.1 USB Connectivity
1. USB port and SmartVISION
CAUTION
TM
Pro CCD connection port are located on right side of laser machine.
USB Port
SmartVISION
TM
Pro CCD Connection
Port
28
Advertisement
Table of Contents
