Startup; Operation - Kärcher WRS 200 Manual

WARNING
Risk of injury from high-pressure jet or electric shock.
Check that the device, accessories, supply lines and connections
are in a correct condition before using the device.
Only use the device when it is in a correct condition.
Connect the high-pressure hose and high-pressure
The high-pressure hose is stored in a storage compartment be-
hind the right-hand door.
The high-pressure gun with spray lance is located in holders at-
tached to the left front side of the WRS 200.
High-pressure hose
1
High-pressure gun
2
Left door rubber latch
3
Door handle
4
Holder with rubber latch
5
Spray lance
6
Mounting
7
1. Release the rubber latch on the right-hand door (at the top
side) and open the door.
2. Remove the high-pressure hose.
3. Release the rubber latch from the upper holder.
4. Remove the high-pressure gun with spray lance.
5. Connect the high-pressure hose to the high-pressure gun.
High-pressure hose
1
WRS 200 high-pressure connection
2
Switchover valve
3
Upper position: Operation with high-pressure gun
Lower position: Operation with high-pressure gun closed
Lower position (with front bar option): Switchover to front bar

operation

Water hose to water connection
4
6. Connect the high-pressure hose to the high-pressure connec-
tion.
24

Startup

gun
Connecting the water hose
Establish the water supply to the WRS 200 (GEKA coupling). En-
sure that the mains is disconnected!.
Water hose
1
WRS 200 water connection
2
Front bar connection (option)
3
1. Connect the water hose to the WRS 200.
ATTENTION
Pump running dry
Damage to the device
If pressure does not build up in the device after 2 minutes then
switch the device off and proceed according to the instructions in
the chapter "Help in case of malfunctions".
ATTENTION
Risk of damage
Always keep the doors closed when working and driving.
The high-pressure cleaner is operated by the hydraulic PTO con-
nection on the vehicle.
The burner can be switched-in for generating hot water.
High-pressure cleaner
1
Pressure control
2
Pressure gauge
3
Oil filler opening
4
1. The high-pressure cleaner is intended for use as a hot water
high-pressure cleaner for the elimination of weeds and as a
cold water high-pressure cleaner for cleaning regions that are
difficult to access.
2. The water jet is applied using a high-pressure gun with spray
lance and a corresponding nozzle attachment.
3. Weed elimination can also be performed over larger areas us-
ing an optional front bar. Contact Kärcher for more information.
English
Operation
High-pressure cleaner