Fitting The Adapter To The Vehicle; Attaching The Top Mount; Upper Link Position - Kärcher WRS 200 Manual

Fitting the adapter to the vehicle

The adapter with coupling triangle is attached to the rear of the
vehicle for mounting the WRS 200.
Adapter with coupling triangle
1
Bolts with spring pins (2x)
2
Screws (2x)
3
1. Slide the adapter into the mounting frame.
2. Secure the adapter with 2 bolts and spring pins.
3. Tighten the screws to prevent play between the frame and
adapter.

Attaching the top mount

The top mount stabilises the WRS 200 during operation. This
must be attached once only before using the device. The holes
for attaching the mount are already present.
For the MIC 35/42 (platform C), mounting is performed below the
air holes.
For the MC 130 or MIC 50/70 (platform D), mounting is performed
above the air holes. The following description shows the mount-
ing for platform D.
Unless specified otherwise, all nuts and screws are to be tight-
ened to the standard torque.
Reinforcement plate (2x)
1
Right-hand holder
2
Left holder
3
Upper links (2x)
4
Screws M16x120 (2x)
5
Screws M16x100 (2x)
6
M16 stop nuts (4x)
7
18x200 Washers (8x)
8
Mount fastening material
9
– M8x30 screws (8x)
– M8 nuts (8x)
– 8x200 washers (14x)
16x200 washers (8x)
10
Screw, washer, nut
11
– For mounting the upper link on platform D
1. Check the scope of delivery.
Mount attachment for platform D (MC 130, MIC 50/70)
1
Mount attachment for platform C (MIC 35/42)
2
Reinforcement plate
3
Outer screw
4
Note
Install this screw without a washer
Upper mount cutout
5
2. Attach the reinforcement plate with mount on the WRS 200
(observe the correct mounting procedure according to the plat-
form).
3. Use screws with washers and nuts.
At the mount side: Fit the outer screw without a washer.
4. Attach the right-hand mount in the same manner.
The upper link must be attached differently for platform C and
platform D.
Position for platform D
1
Position for platform C
2
Screw
3
Stop nut
4
Upper link
5
1. Attach the upper link in the corresponding position using a
screw and stop nut.
English

Upper link position

21