Kärcher WRS 200 Manual page 23

Left-hand door
1
Fuel canister
2
Retaining strap
3
Tank cap with fuel lines
4
Detergent container
5
1. Release the rubber latch on the left-hand door and open the
door.
2. Release the retaining strap from the canister.
3. Open the tank cap and allow any fuel to drip off before remov-
ing the cap.
4. Fasten the tank cap with fuel lines open at the top.
5. Remove the canister.
6. Refill with Diesel.
7. Insert the canister and secure with the retaining strap.
8. Fit the tank cap with fuel lines.
9. Close the tank cap.
10.Wipe off any spilt fuel.
11.Close the left-hand door and secure with the rubber latch.
Filling the system care container
The RM 110 system care liquid (descaler) is a highly effective
agent for preventing calcification of the heating coil when operat-
ing with hard water. This is drip-fed dosed into the water supply.
The dosage is set at the factory for water hardnesses of up to ap-
prox. 30 °dH. The dosing valve can be adjusted if necessary. See
chapter "Adjusting dosage".
ATTENTION
Health risk
Observe the safety and handling instructions for handling RM
110.
System care container
1
Cover
2
1. Open the lid of the system care container.
2. Add RM 110 system care liquid to the container, do not overfill.
Maximum filling level is 2 cm below the filling edge.
3. Close the cover.
The dosage is set at the factory for water hardnesses of up to ap-
prox. 30 °dH (position between 1 and 2). Change the position if
necessary.
Bar
1
Cover
2
1. Remove the bar by removing the 2 screws (marked with ar-
rows) using a socket wrench.
2. Remove the cover.
Cover
1
Dosing pump
2
Position 1
3
Note
Up to 10 °dH
Position 2
4
Note
Up to 55 °dH
3. Adjust position 1 to 2 for the desired degree of water hardness.
Higher positions are irrelevant because these degrees of hard-
ness do not occur.
4. Attach the cover.
5. Attach the bar.
English
Adjusting the dosage
23