Fitting And Connecting The Wrs 200; Pre-Commissioning - Kärcher WRS 200 Manual

Fitting and connecting the WRS 200

The WRS 200 is attached to the adapter with coupling triangle
and secured by a screw.
It is additionally fastened to the vehicle by the upper links.
We recommend using the help of a second person for attaching
the device.
WRS 200
1
Lift truck
2
Adapter with coupling triangle
3
1. Use the lift truck to position the WRS 200 approximately 30 cm
in front of the adapter and then lift it until it is positioned above
the adapter.
Hydraulic hoses
1
Water connection
2
Cable with plug
3
2. Connect the hydraulic hoses to the WRS 200 and insert them
into the PTO hydraulic connection on the vehicle (observe the
correct flow direction).
3. Connect up the water hose.
4. Insert the cable with plug into the trailer socket.
Screw (retainer)
1
22
WRS 200
2
5. Slowly move the WRS 200 forwards as far as it will go and
then lower it into the adapter coupling triangle.
6. Secure the WRS 200 with the screw. Tightening torque 80 Nm.
Upper link adjusting nut
1
Lock nut
2
Retaining pin with retaining clip (platform C)
3
7. Attach the left-hand and right-hand upper links to the vehicle.
a Platform C: Attach using the existing retaining pins on the
vehicle and secure with the clips (see illustration).
b Platform D: Attach to the vehicle using screw, washers and
nuts (included in the delivery).
8. Adjust the position of the WRS 200 using the adjusting nuts
and secure with the counter-nuts.
WARNING
Risk of injury
Check that the battery, accessories, supply lines, water filter and
connections are in a correct condition before using the device.
Only use the device when it is in a correct condition.
1. Check the filling level in the fuel canister and fill if necessary.
2. Check the filling level in the system care container and fill with
RM 110 if necessary.
3. Check the filling level in the water tank and fill if necessary.
4. A licence plate (repeater licence plate) must be attached be-
fore use on public roads. The license plate must be attached
centrally with a 40 mm clearance, parallel to the tail lights.
DANGER
Explosion hazard due to overflowing fuel
Take care ensure that no fuel spills onto hot surfaces when refu-
elling.
DANGER
Explosion hazard due to smoking and naked flames
Ensure strict prohibition of smoking and open flames during the
refuelling procedure.
WARNING
Health risk from inhaled vapours
Do not refuel in confined spaces.
ATTENTION
Risk of damage due to incorrect fuel
Refuel with Diesel only.
ATTENTION
Risk of damage due to the fuel pump running dry
Check the filling level of the fuel canister regularly, refuel in time
as necessary.
Note
Refill with fuel only when the canister is detached. Use only orig-
inal canisters.
English

Pre-commissioning

Refuelling