Setting The Power Supply Used (Power Source) - Zoom F4 Operation Manual

Setting the power supply used (Power Source)

Set the DC power supply shutdown voltage, nominal voltage and type of batteries so that the remaining power supply charge
can be shown accurately.
On this menu page, you can check the voltage of each power supply and the remaining battery capacity.
1.
Press m.
2.
Use e to select SYSTEM,
and press E.
3.
Use e to select Power
Source, and press E.
▶ Continue to one of the following procedures.
Setting the DC power supply (DC IN)
shutdown voltage ............................................................................ P .20
Setting the DC power supply (DC IN)
nominal voltage ............................................................................... P .21
Setting the type of AA batteries (Int AA) ........................................ P .21
20
Setting the DC power supply (DC IN) shutdown volt-
age
If the voltage becomes less than the value set here when using a DC
power supply, the F will automatically stop recording and turn
off.
If AA batteries (Int AA) are installed, however, the power supply will
switch to them and operation will continue.
4.
Use e to select Shutdown
Voltage, and press E.
HINT
• The shutdown voltage is the voltage level that the exter-
nal DC power supply runs out and can no longer supply
power.
• See the DC power supply manual for the shutdown volt-
age value.
5.
Use e to select the volt-
age, and press m.