Setting The Power Supply Used By The R; (Power Source) - Zoom F4 Operation Manual

Setting the power supply used by the R (Power Source)
Set the DC power supply shutdown voltage, nominal voltage and type of batteries so that the remaining power supply charge
can be shown accurately.
On this menu page, you can check the voltage of each power supply and the remaining battery capacity.
1.
Press m.
2.
Use e to select USB,
and press E.
3.
Use e to select FRC-8,
and press E.
4.
Use e to select Power
Source, and press E.
128
Setting the power source for the R is the same
as for the F. See "Setting the power supply used (Power
Source)" (→ P .20).
▶ Continue to one of the following procedures.
Setting the DC power supply (Ext DC) shutdown voltage ..................... P .20
Setting the DC power supply (Ext DC) nominal voltage ............... P .21
Setting the type of AA batteries (Int AA) ........................................ P .21
NOTE
When multiple power supplies are connected, they will be used in
the following order of precedence.
1. DC power supply (Ext DC)
2. USB bus power (supplied by F)
3. AA batteries (Int AA)
The voltages of each power supply are shown on the display.