Install the Display Module
Install the
the Display
Display Module
Install
Install
the
Display
1. Use the screws (11) to mount the bracket (10) for
the Advanced Display Module (12) on the front of
the Control Box or on the wall.
2. Snap the Advanced Display Module into the
bracket.
Figure 13 Install Display Module
3. Connect one end of the 5 ft (1.5 m) CAN cable
(provided) to the Advanced Display Module
(M). The other end of the cable comes from the
factory connected to the Enhanced Fluid Control
Module (EFCM).
NOTE:
NOTE:
NOTE: For a list of alternate cable lengths, see
Electrical Schematics, page
all cable used in the system must not exceed 150
ft (45 m).
Figure 14 Advanced Display Module Connection
Ports
26
Module
Module
41. The total length of
Item
Item
Item
J
K
L
M
N
P
R
Description
Description
Description
Battery Cover
Model Number
USB Drive Interface
CAN Cable Connection
ADM Status LEDs
Accessory Cable
Connection
Token Access Cover
332458M