Advertisement
Installation
Installation
Installation
To reduce the risk of injury, follow the Pressure
Relief Procedure
Procedure in your Pro Xp manual before
Relief
Relief
Procedure
installing this kit.
1. Relieve the pressure.
2. Remove the retaining ring, air cap/tip guard, and
spray tip.
3. Flush the gun as instructed in your gun manual.
Relieve the pressure.
NOTICE
NOTICE
NOTICE
Do not operate the gun with a damaged
electrode (4a). Make sure the electrode is in
place before installing the air cap/electrode
assembly (4).
NOTE: The kit includes a large retainer (2) for
NOTE:
NOTE:
a larger pattern, and a small retainer (3) for a
smaller pattern.
4. Check that the electrode (4a) is in place in the air
cap. The two ends of the electrode should be
inserted in the two holes on the back of the air
cap, and should protrude through the front of the
air cap. Install the diffuser/seal assembly (1), air
cap/electrode assembly (4), and desired retainer
(2 or 3) onto the gun. Tighten the retainer firmly.
2
Pressure
Pressure
NOTICE
NOTICE
NOTICE
Overtightening the spray tip (5) can damage
the tip and cause poor spray performance.
5. Install the spray tip (5) and tighten using the
wrench (6). When tightening, only grip the end
of the wrench with your fingers. Do not grip the
wrench cross-arms (E).
6. Adjust the spray pattern as explained in the Gun
Setup Checklist of your Pro Xp gun manual.
NOTE:
NOTE: The recommended spraying distance
NOTE:
from the front of the gun to the object being
sprayed is 8–12 in. (203–305 mm). Round spray
tips emit a soft pattern. If the gun is too far from
the object, the floating charged particles may be
attracted to the gun or operator instead of to the
grounded object.
NOTE: See
NOTE:
NOTE:
Round Spray Tips, page 5
for fluid flow information. See
Spray Pattern Troubleshooting, page 4
to correct spray pattern problems.
NOTE: If the spray tip clogs, stop spraying
NOTE:
NOTE:
immediately and relieve pressure. Clean the tip
as explained in your Pro Xp gun manual. To help
reduce spray tip clogging, clean or replace the
fluid filter supplied with the gun.
,
,
3A2499D
Advertisement
