Changing Oil And Filter - Mercury MR504LB3 Manual

1. Remove the oil fill cap.
b
a
2. Add the specified oil to bring the oil level up to, but not over, the maximum mark on the dipstick.
2.0L
Engine oil (with filter)
IMPORTANT: When filling the engine with oil, always use the dipstick to confirm the oil level.
3. Install the oil fill cap.

Changing Oil and Filter

Refer to the Maintenance Schedule for the change interval. Change the engine oil before placing the boat in storage.
IMPORTANT: Change the engine oil when the engine is warm from operation. Warm oil flows more freely, carrying away more
impurities. Use only recommended engine oil.
2.0L
Engine oil (with filter)
1. Start the engine and allow it to warm up to normal operating temperature.
2. Stop the engine and allow the oil to drain into the oil pan for approximately five minutes.
3. Place a suitable container under the oil filter housing to capture any spilled oil. Use an appropriate socket to loosen the oil
filter cover.
4. Remove the drain plug on the oil filter housing and allow to drain into a suitable container.
5. Remove the oil filter cover and oil filter.
6. Discard the oil filter and O‑ring.
b
a
7. Apply sealant to the threads of the oil filter housing drain plug and install.
90-8M0089579 MARCH 2014
eng
c
Engine Oil
System Capacity
5.2 L (5.5 US qt)
Engine Oil
System Capacity
5.2 L (5.5 US qt)
b
c
d
53087
2.0L engine oil service
a - Engine cover with access panel removed
b - Engine oil fill cap
c - Engine oil dipstick
27986
Fluid Type
5W‑30 Full Synthetic TDI Engine Oil
Fluid Type
5W‑30 Full Synthetic TDI Engine Oil
a - Drain plug
b - Oil filter cover
c - O‑ring
d - Oil filter
Section 5 - Maintenance
Part Number
92‑8M0069603
Part Number
92‑8M0069603
Page 47