Mitsubishi CRn-500 Series Instruction Manual page 9

Additional axis interface

Hide thumbs Also See for CRn-500 Series:

Table of Contents

Preface

Thank you for purchasing Mitsubishi Electric Industrial Robot CRn-500 Series.

The additional axis interface is a general-purpose servo amplifier control interface in combination with

CRn-500 Series controller.

Before use, be sure to read this manual for sufficient understanding. Then use the additional axis in-

terface.

・ No part of this manual may be reproduced by any means or in any form, without prior

consent from Mitsubishi.

・ The details of this manual are subject to change without notice

・ An effort has been made to make full descriptions in this manual. However, if any dis-

crepancies or unclear points are found, please contact your dealer.

・ The information contained in this document has been written to be accurate as much as

possible.

Please interpret that items not described in this document "cannot be performed." or

"alarm may occur".

・ This Instruction Manual is original.

Table of Contents