Siemens ULTRAMAT 6 Manual page 98

Hide thumbs Also See for ULTRAMAT 6:
Table of Contents

Advertisement

Available languages

Available languages

3.1.6
Physical Block with ULTRAMAT, OXYMAT and CALOMAT
Device-specific properties can be displayed/set using parameters in the physical block.
Rel.
Parameter
Index
8 SOFTWARE_REVISION
9 HARDWARE_REVISION
10 DEVICE_MAN_ID
11 DEVICE_ID
12 DEVICE_SER_Num
13 DIAGNOSIS
15 DIAGNOSIS_MASK
17 DEVICE_CERTIFICATION
18 WRITE_LOCKING
19 FACTORY_RESET
20 DESCRIPTOR
21 DEVICE_MESSAGE
22 DEVICE_INSTAL_DATE
23 LOCAL_OP_ENA
24 IDENT_NUMBER
36 DEVICE_CONFIGURATION
ULTRAMAT 6 / OXYMAT 6 / CALOMAT 6 / ULTRAMAT 23 / OXYMAT 61
Schnittstelle PROFIBUS DP / PA Interface
A5E00054148-03
Description
Firmware version of the device
Hardware version of the device
Manufacturer's code
Manufacturer's identification:
Serial number of the device
Bit encoded standard diagnostic messages
Bit mask indicating which DIAGNOSIS bits are supported.
Details about certification in plain text
Write protection function. Write access is refused with the error
code access denied.
Command to trigger reset functions in the device:
• 0:
No action.
• 1:
Reset all parameters to the factory settings. Except for
the set station address, the IDENT_NUMBER
parameter and the ST_REV. The device shows the
following cold start in the corresponding bit of
DIAGNOSIS for 10 sec.
• 2506: Initiate a device warm start. The device shows the
following cold start in the corresponding bit of
DIAGNOSIS for 10 sec.
• 2712: Reset the station address to the normal PROFIBUS
default address 126.
Option to store a description of the device within an application.
Option to store a message about the device within an application.
Installation date of the device
Enable local operation
Each PROFIBUS device must check an identification number
issued by the PNO in the
configuration behavior of the device here:
• 0: Only the PROFILE identification number is acknowledged
positively.
• 1: Only the device-specific identification number is
acknowledged positively.
Description of the device configuration
SIEMENS AG = 42
e.g. ULTRAMAT 23
Configuration
Phase. The user sets the
98

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents