Siemens ULTRAMAT 6 Manual page 121

7.4.4 ULTRAMAT 23 Diagnostic Information
Fault (F) Meaning of fault/maintenance request
Maintenance
request (M)
No.
S1 Channel 1 measured value outside limits
S2 Channel 2 measured value outside limits
S3 Channel 3 measured value outside limits
S4 O2 measured value outside limits
S5 Mains voltage outside limits
S6 Device temperature outside limits
S7 Air pressure outside limits
S8 No flow during measurement
S9 No temperature adjustment carried out
S10 No flow with AUTOCAL
S11 O2 measured value too small
S12 Analog flow output faulty
S13 Sumcheck error of all IR channels
S14 Fault of address for IR channels
S15 AUTOCAL drift too large
S16 EEPROM error
S17 Phase not found
S18 Serial interface fault
S19
S20 Channel 1 not calibrated
S21 Channel 2 not calibrated
S22 Channel 3 not calibrated
S23 Transmitter voltage outside limits
S24 Bridge supply voltage outside limits
S25 Bridge half voltage outside limits
S26 Lockin error
S27 External fault
S28
S29
S30
S31 O2 sensor sensitivity too low
S32 External ADC error
W1 AUTOCAL drift too large
W2 O2 sensor
W3 LCD temperature outside limits
W4 External maintenance request
ULTRAMAT 6 / OXYMAT 6 / CALOMAT 6 / ULTRAMAT 23 / OXYMAT 61
Schnittstelle PROFIBUS DP / PA Interface
A5E00054148-03
Diagnostic Diagnosis bit name
byte/bit
1 / 5 DIA_MEASUREMENT
1 / 5 DIA_MEASUREMENT
1 / 5 DIA_MEASUREMENT
1 / 5 DIA_MEASUREMENT
2 / 1 DIA_SUPPLY
1 / 1 DIA_HW_MECH
2 / 1 DIA_SUPPLY
2 / 1 DIA_SUPPLY
1 / 7 DIA_INIT_ERR
2 / 1 DIA_SUPPLY
1 / 1 DIA_HW_MECH
1 / 5 DIA_MEASUREMENT
1 / 0 DIA_HW_ELECTR
1 / 1 DIA_HW_MECH
1 / 5 DIA_MEASUREMENT
1 / 1 DIA_HW_MECH
2 / 0 DIA_ZERO_ERR
1 / 4 DIA_MEM_CHKSUM
2 / 2 DIA_CONF_INVAL
1 / 1 DIA_HW_MECH
1 / 0 DIA_HW_ELECTR
1 / 7 DIA_INIT_ERR
1 / 7 DIA_INIT_ERR
1 / 7 DIA_INIT_ERR
1 / 0 DIA_HW_ELECTR
1 / 0 DIA_HW_ELECTR
1 / 0 DIA_HW_ELECTR
1 / 0 DIA_HW_ELECTR
1 / 1 DIA_HW_MECH
1 / 1 DIA_HW_MECH
1 / 0 DIA_HW_ELECTR
2 / 5 DIA_MAINTENANCE
2 / 5 DIA_MAINTENANCE
1 / 3 DIA_TEMP_ELECTR
2 / 5 DIA_MAINTENANCE
2 / 5 DIA_MAINTENANCE
121