Siemens ULTRAMAT 6 Manual page 89

2.8.3 Installing the ULTRAMAT 23 Optional Module
☛
Note
With the ULTRAMAT 23 only the A5E00034504 module can be installed for non-intrinsically safe
connection to PROFIBUS-PA and the A5E00019145 module for connection to the PROFIBUS-DP.
•
Disconnect the device from the mains
•
Unscrew and remove the housing cover
•
Remove the old optional module if installed
•
Fasten the module with the M3 screws to the rear panel between connectors
•
Fasten the module to the housing base with plastic bolt (included in add-on kit).
•
Connect the connectors to the motherboard
•
Screw on housing cover
•
Connect the device to the PROFIBUS
•
Connect the device to the mains
Rear panel
Optional module
ULTRAMAT 6 / OXYMAT 6 / CALOMAT 6 / ULTRAMAT 23 / OXYMAT 61
Schnittstelle PROFIBUS DP / PA Interface
A5E00054148-03
Motherboard
Fastening bolt
Connect 26-pin
ribbon cable
Fig. 2.3
89