ABB IRC5 Compact Product Manual page 164

4 Repair
4.11 Replacement of SD-card memory in computer unit
Continued
Equipment
Standard toolkit
Removal
Use the following procedure to remove the SD-card memory.
1
2
3
4
Refitting
Use the following procedure to refit the SD-card memory.
1
2
3
4
5
164
Action
DANGER
Before commencing any work inside the cabinet, please observe the safety inform-
ation in section DANGER - Make sure that the main power has been switched off!
on page 33.
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit please observe the safety
information in section
Remove the attachment screw and open the hatch on the right hand side of the
controller.
Gently push the SD-card memory with your finger until it clicks, and then pull it
straight out.
Action
DANGER
Before commencing any work inside the cabinet, please observe the safety information
in section DANGER - Make sure that the main power has been switched off! on page
ELECTROSTATIC DISCHARGE (ESD)
The unit is sensitive to ESD. Before handling the unit please observe the safety inform-
ation in section WARNING - The unit is sensitive to ESD! on page 34
CAUTION
Make sure that the SD-card memory is correctly oriented before inserting it. Otherwise
the SD-card memory or the SD-card memory slot may be damaged.
Gently push the SD-card memory with your finger until it clicks into place.
Perform the function tests in section
features work properly.
© Copyright 2009-2017 ABB. All rights reserved.
Note
The content is described in section
Standard toolkit, IRC5 on page
WARNING - The unit is sensitive to ESD! on page 34
Function tests on page 118
207.
to verify that the safety
Product manual - IRC5 Compact
3HAC047138-001 Revision: G
33.