Devicenet I/O Units - ABB IRC5 Compact Product Manual

2 Installation and commissioning

2.10.2 DeviceNet I/O units

2.10.2 DeviceNet I/O units
General
The IRC5 controller may be fitted with DeviceNet I/O or encoder units. These are
configured in an identical way.
Standard configuration
In the standard form, no fieldbus is mounted to the controller.
It is possible to connect any type of DeviceNet compliant I/O unit on the DeviceNet
- master bus. All I/O units should comply with the DeviceNet standard and be
conformance tested by ODVA.
DeviceNet I/O units and parts
The table below specifies the DeviceNet I/O units:
Description
Digital I/O
See
Encoder interface units
The table below specifies the encoder interface units:
Description
Encoder interface unit for conveyor
tracking
Further information
The table below gives references to additional information:
Information:
How to install the DeviceNet I/O
units mechanically and electrically.
Allowed configurations of Devi-
ceNet I/O units and how to setup
the configurations.
How to install the DeviceNet I/O unit
software related in a new system.
Detailed descriptions of all available
DeviceNet I/O units.
98
Spare parts on page 209
© Copyright 2009-2017 ABB. All rights reserved.
Note
DSQC 652
for the spare part numbers.
Art. no.
3HNE 01586-1
Found in:
Fit the expansion board and/or field bus adapter ac-
cording to Replacement of expansion board in the
computer unit on page 151
fieldbus adapter in the computer unit on page
Technical reference manual - System parameters
The application manual for the different I/O buses re-
spectively, see listing in
on page 94.
The application manual for the different I/O buses re-
spectively, see listing in
on page 94.
Product manual - IRC5 Compact
Note
DSQC 377B
and/or Replacement of
154.
Definition of fieldbuses, IRC5
Definition of fieldbuses, IRC5
3HAC047138-001 Revision: G