Led Lamp - Epson LS10-B Series User Manual

Maintenance 12. LED Lamp

12. LED Lamp

■ Do not connect or disconnect the motor connectors while the power to the robot
system is turned ON. Connecting or disconnecting the motor connectors with
the power ON is extremely hazardous and may result in serious bodily injury as
the Manipulator may move abnormally, and also may result in electric shock
and/or malfunction of the robot system.
■ To shut off power to the robot system, disconnect the power plug from the power
source. Be sure to connect the AC power cable to a power receptacle.
WARNING
DO NOT connect it directly to a factory power source.
■ Before performing any replacement procedure, turn OFF the Controller and
related equipment, and then disconnect the power plug from the power source.
Performing any replacement procedure with the power ON is extremely hazardous
and may result in electric shock and/or malfunction of the robot system.
Maintenance
LED Lamp
parts
Cross-point screwdriver
Tools
Nippers
Wire tie
Material
(1) Remove the Arm Top Cover.
LED Lamp
Removal
(2) Remove the User Plate.
(3) Disconnect the X1 and X2 terminals from the
(4) Turn the lens counterclockwise to remove.
(5) Remove the LED and ring from the User Plate.
LED Lamp (1) Connect the X1 and X2 terminals to the LED.
Installation
(2) Put the User Plate between the ring and lens
(3) Mount the lens.
(4) Mount the User Plate.
(5) Install the Arm Top Cover.
148
Name
For details, refer to Maintenance: 3.1 Arm Top Cover.
For details, refer to Maintenance: 3.5 User Plate.
LED.
Then, turn the lens holder counterclockwise to
remove.
Each terminal must be connected to the same
terminal number on the LED.
holder, and then secure the LED to the cover.
For details, refer to Maintenance: 3.5 User Plate.
For details, refer to Maintenance: 3.1 Arm Top Cover.
Qty. Note
1
2077258
1 For wire removal
1
1
Lens
Lens Holder
Ring
LED
X2
X1
Terminal
Terminal
LS10-B Rev.6