Note:
RIP cannot be configured on the WAN Interface which has NAT enabled (such as PPPoE).
4.11 IPv6 Route Settings
Choose
IPv6 Route
Settings, it includes two
The detailed descriptions are provided below.
4.11.1 IPv6 Default Gateway
Go to
IPv6 Route Settings
You can select a WAN Interface from the drop-down list as the system default gateway.
Click
Add
Interface, you can add WAN Interfaces.
Click
Save
to make the settings effective.
4.11.2 IPv6 Static Route
Go to
IPv6 Route Settings
screen allows you to configure the IPv6 static routes. An IPv6 static route is a pre-determined path
that network information must travel to reach a specific host or network.
To add a new entry, follow the instructions below.
1.
Click
Add
New, and you will see the screen as shown below.
menus: IPv6 Default Gateway
IPv6 Default
Gateway, you can see the Default Gateway screen.
→
IPv6 Static
Route. You can see the IPv6 Static Route screen. This
→
72
TD-W9970 User Guide
and
IPv6 Static
Route.