Wireless Status - TP-Link TD-W9970 User Manual

Transmit Power:

High, Middle or Low which you would like. High is the default setting and is recommended.
Beacon Interval:

beacons are the packets sent by the modem router to synchronize a wireless network.
Beacon Interval value determines the time interval of the beacons. The default value is 100.
RTS Threshold: Here you can specify the RTS (Request to Send) Threshold. If the packet is

larger than the specified RTS Threshold size, the modem router will send RTS frames to a
particular receiving station and negotiate the sending of a data frame. The default value is
2346.
Fragmentation Threshold:

be fragmented. Setting the Fragmentation Threshold too low may result in poor network
performance because of excessive packets. 2346 is the default setting and is recommended.
DTIM Interval: This value determines the interval of the Delivery Traffic Indication Message

(DTIM). A DTIM field is a countdown field informing clients of the next window for listening to
broadcast and multicast messages. When the modem router has buffered broadcast or
multicast messages for associated clients, it sends the next DTIM with a DTIM Interval value.
You can specify the value between 1-255 Beacon Intervals. The default value is 1, which
indicates the DTIM Interval is the same as Beacon Interval.
Enable Short GI:

reducing the guard interval time
Enabled Client isolation:

each other. Wireless devices will be able to communicate with the modem router but not with
each other. To use this function, check this box. Client isolation is disabled by default.
Enable WMM: WMM

transmitted preferentially. It is strongly recommended.

Note:
If you are not familiar with the setting items in this page, it's strongly recommended to keep the
provided default values; otherwise it may result in lower wireless network performance.

4.7.7 Wireless Status

Go to Wireless Wireless
→
Packets and Sent Packets for each connected wireless station.
MAC Address: The connected wireless station's MAC address

Current Status:

STA-AUT H/STA-ASSOC/STA-JOINED/WPA/WPA-PSK/WPA2/WPA2-PSK/AP-UP/AP-DOW
N/Disconnected
Received Packets:

Sent Packets: Packets sent by the station

Here you can specify the transmit power of modem router. You can select
Enter a value between 25-1000 milliseconds for Beacon Interval here. The
This value is the maximum size determining whether packets will
This function is recommended for it will increase the data capacity by
.
This function can isolate wireless stations on your network from
function can guarantee the packets with high-priority messages being
Status, you can see the MAC Address, Current Status, Received
The connected
Packets received by the station
wireless station's
60
TD-W9970 User Guide
running status, one of