Settings - TP-Link TD-W8968 User Manual

4.4.3 3G Settings
Go to Advanced Setup
screen below. To use the 3G function, you should first insert your USB modem on the USB port
of the modem router. There is already much 3G USB modem information embedded in the
modem router. The USB modem parameters will be set automatically if the card is supported by
the modem router. If your USB modem inserted is supported by the modem router,
successfully will display in the USB 3G Modem field as shown below.
Some 3G USB modem may not be supported by the modem router. For more information,
please refer to Compatibility List
incompatible with our modem router, please feel free to contact our Technical Support.
Location: The location where you're enjoying the 3G card.

Mobile ISP: The ISP (Internet Service Provider) you apply to for 3G service. The modem

router will show the default Dial Number and APN of that ISP.

Note:
If your Location or
ISP Information. Then fill the
Dial on demand: Dial on demand is dependent on the traffic. If there is no traffic (or Idle) for

a pre-specified period of time
automatically. And once there is traffic send or receive, the connection will be automatically
on. If you want your Internet connection to remain active at all times, enter
Timeout field.
→ 3G Settings, and you can configure parameters for 3G function on the
on our website www.tp-link.com. If your 3G USB modem is
Mobile ISP is not listed, please untick the box before
Dial Number
(Inactivity
and APN blanks below.
Timeout), the connection will drop down
27
TD-W8968 User Guide
Identify
Automatically fill
0 in the Inactivity