Note:
To completely configure the WAN Interface, you need to first select the Layer2 Interface
Layer2
Interface) according to the connection ISP provides for you, and then to select the type
of the connection
(4.4.2 WAN
4.4.1 Layer2 Interface
4.4.1.1 ATM Interface
Go to
Advanced Setup
on the screen below.
Remove:
Select the check box in the table on the screen above and then click the
button, the corresponding interface will be deleted in the table.
Note:
If the interface is used by the configuration of the
corresponding WAN Service entry first before you can remove it here.
Add:
Click the button, and you can add a new interface in the next screen.
VPI/VCI:
The VPI and VCI values are provided by your ISP. Do not change them unless it
was required by your ISP.
DSL Link Type:
Select a DSL Link Type which is provided by your ISP. The options include
EoA
(it is for PPPoE, IPoE, and Bridge),
Service) for the further configuration.
→
Layer2 Interface
→
PPPoA
ATM
Interface, you can configure ATM interfaces
4.4.2 WAN
Service, you need to remove the
(PPP over ATM) and
16
TD-W8968 User Guide
(4.4.1
Remove
IPoA
(IP over ATM).