TP-Link TD-W8968 User Manual page 35

IP Address: Enter the modem router's local IP Address, and then you can access to the

web management page via the IP Address. The default value is 192.168.1.1.
Subnet Mask: Enter the modem router's Subnet Mask, the default value is 255.255.255.0.

Enable IGMP Snooping:

Mode or Blocking Mode.
DHCP Server: These settings allow you to configure the modem router's Dynamic Host

Configuration Protocol (DHCP) server function. The DHCP server is enabled by default for
the modem router's Ethernet LAN interface. DHCP service will supply IP settings to
computers which are configured to automatically obtain IP settings that are connected to
the modem router through the Ethernet port. When the modem router is set for DHCP, it
becomes the default gateway for DHCP client connected to it. Keep in mind that if you
change the IP address of the modem router, you must change the range of IP addresses in
the pool used for DHCP on the LAN.
 Start IP Address:
addresses. Because the default IP address for the modem router is 192.168.1.1, the
default Start IP Address is 192.168.1.2, and the Start IP Address must be 192.168.1.2 or
greater, but smaller than 192.168.1.254.
 End IP Address:
addresses. The End IP Address must be smaller than 192.168.1.254. The default End IP
Address is 192.168.1.254.
 Leased Time (hour):
be allowed connection to the modem router with their current dynamic IP address.
Enter the amount of time, in hours, then the user will be "leased" this dynamic IP address.
If you select the option, please choose the IGMP Mode: Standard
Enter a value for the DHCP server to start with when issuing IP
Enter a value for the DHCP server to end with when issuing IP
The Leased Time is the amount of time in which a network user will
31
TD-W8968 User Guide