Drive System Maintenance; Checking The Tire Pressure; Checking The Tires And Lug Nuts; Servicing The Transmission And Axles - Toro Pro Sneak 360 Operator's Manual

Drive System
Maintenance

Checking the Tire Pressure

Service Interval: Before each use or daily
Maintain the air pressure in the tires as specified. Check the
tires when they are cold to get the most accurate reading.
Tire Size Ply Rating
23 x 10.5 x 12 4
26 x 12 x 12 8
Note: Use a lower tire pressure when operating in sandy soil
conditions to provide better traction in the loose soil.
Checking the Tires and Lug
Nuts
Service Interval: Before each use or daily—Check the tire
pressure.
Before each use or daily—Check the lug nuts.
•
Do not exceed the rated tire pressure. To ensure long tire
life and safe handling, check tire pressure daily, refer to
Checking the Tire Pressure (page 27).
•
Proper Care-Inspect tires for cuts, slashes, or bulges.
Tires with defects need to be replaced or repaired for
proper handling and safety.
•
Check daily to ensure that all lug nuts are tight. Torque
the lug nuts to 81-95 N-m (60-70 ft-lbs).
3
5
Figure 31
Pressure
kPa psi
138 20
207 30
1
4
2
g023497
Servicing the Transmission
and Axles
Transmission oil specification: SAE 80W140 API
classification level GL5
Transmission oil capacity: approximately 0.47 L (0.5 qt)
Toro Premium Gear Oil is available from an Authorized
Service Dealer. See the parts catalog for part numbers.
Axle oil specification: SAE 80W140 API classification level
GL5
Front axle oil capacity: approximately 2.4 L (2.5 qt)
Rear axle oil capacity: approximately 2.4 L (2.5 qt)
Toro Premium Gear Oil is available from an Authorized
Service Dealer. See the parts catalog for part numbers.
Checking the Transmission Oil
Service Interval: Every 250 hours
1. Park the machine on a level surface, lower any
attachments, and stop the engine.
2. Clean the area around the fill plug with a cleaning
solvent (Figure 32).
1. Fill plug
3. Remove the fill plug.
4. Check the oil level.
Note: The level should be even with the bottom of
the fill plug.
5. If the oil level is below the bottom of the fill plug hole,
add oil to raise the level up to the bottom of the fill
plug hole.
6. Install the fill plug.
27
1
2
g022229
Figure 32
2. Drain plug