Toro Pro Sneak 360 Operator's Manual page 13

Move the lever to the neutral position to stop the machine.
From the neutral position, push the lever slightly for forward
ground travel. Push the lever farther to increase the forward
ground speed. Pull the lever slightly to decrease the forward
ground speed.
From the neutral position, pull the lever slightly for reverse
ground travel. Pull the lever farther to increase the reverse
ground speed. Push the lever slightly to decrease the reverse
ground speed.
While the machine is in motion push the lever slightly left
or right to turn the machine.
Note: The directional control lever cannot be used when
using the creep control lever.
Parking Brake Lever
To set the parking brake, pull the lever up and push it forward.
To release the parking brake, pull the lever back and down.
Attachment Control Lever
The attachment control lever has two positions: raise and
lower. Pull the lever to raise the attachment. Push the lever to
lower the attachment.
Fuel Gauge
This gauge measures the amount of fuel in the fuel tank
(Figure 5).
1
4
1. Fuel gauge
2. Indicator lights
3. Key switch
2
3
g018916
2 5
Figure 5
4. Hour meter
5. Preheat switch
Key Switch
The key switch, used to start and stop the engine, has 3
positions: on, off, and start.
To start the engine, rotate the key to the start position. Release
the key when engine starts and it will move automatically to
the on position.
To stop the engine, rotate the key to the off position.
Preheat Switch
Use this switch to energize the glow plugs for starting the
engine during cold weather.
Hour Meter
The hour meter displays the number of hours of operation
that have been logged on the machine (Figure 5).
Engine Temperature Warning Light
This light illuminates when the key switch is in Test and the
engine is not running, or if there is a problem with the engine
temperature. If the lamp illuminates when engine is running,
stop the engine, remove the key, and check for the problem.
Refer to your Engine Operator's Manual.
g018915
1. Engine temperature light
2. Hydraulic oil temperature
light
3. Engine oil light
4. Hydraulic oil pressure light 8. Air filter light
Engine Oil Pressure Light
If the engine oil pressure gets too low, this light illuminates. If
this happens, stop the engine and check the oil. If the oil level
is low, add oil and/or look for possible leaks.
Air Filter Warning Light
This light illuminates when the key switch is in test, or when
the engine is running and the air filter is in need of service.
If this light illuminates when the engine is running, stop the
engine, remove the key, and service the air cleaner.
13
1
2
3
4
5
6
7
8
Figure 6
5. Engine oil pressure light
6. Neutral light
7. Battery light