Draining The Fuel Filter/Water Separator; Replacing The Fuel Filter Canister; Draining The Fuel Tank; Electrical System Maintenance - Toro Pro Sneak 360 Operator's Manual

Draining the Fuel Filter/Water
Separator
Service Interval: Every 50 hours—Drain water and other
contaminants from the fuel filter/water
separator.
1. Locate the fuel filter on the right side of the engine
(Figure 27) and place a clean container under it.
Figure 27
1. Fuel filter
2. Loosen the drain valve on the bottom of the filter
canister and allow the water to drain.
3. When finished, tighten the drain valve.
Replacing the Fuel Filter
Canister
Service Interval: Every 250 hours—Replace the fuel filter.
1. Clean the filter head and the outside of the fuel filter.
2. Turn the filter counterclockwise and remove the filter
from the filter head.
3. Lubricate the gasket on the new filter canister with
clean oil.
4. Install the filter canister by hand until the gasket
contacts the filter head, then rotate it an additional
1/2 turn.
5. Start the engine and check for leaks.

Draining the Fuel Tank

Service Interval: Every 2 years—Drain and clean the fuel
tank (See an Authorized Service Dealer).
Have an Authorized Service Dealer drain and clean the fuel
tank.
Electrical System
Maintenance

Servicing the Battery

Service Interval: Every 100 hours—Check the battery
Every 250 hours—Check the battery cable
connections.
1
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
g018962
Important: The following procedures apply when
servicing a (dry) battery that has replaced the original
battery. The original (wet) battery does not require
service.
Always keep the battery clean and fully charged. Use a paper
towel to clean the battery case. If the battery terminals are
corroded, clean them with a solution of 4 parts water and
1 part baking soda. Apply a light coating of grease to the
battery terminals to reduce corrosion.
Voltage: 12 V, 1000 Cold Cranking Amps
Checking the Electrolyte Level
1. Stop the engine and remove the key.
2. Remove the bolts securing the battery tray, located on
both sides of the machine(Figure 28).
1
1. Battery tray
25
electrolyte level (replacement battery
only).
WARNING
CALIFORNIA
Proposition 65 Warning
Wash hands after handling.
Figure 28
2. Bolts
2
g018960