Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
4 Slide the battery out of its socket.
5 Wait two minutes to allow the motherboard electrical components to fully discharge.
6 To insert a new battery, slide it into the socket so that the positive (+) side of the battery
faces up.
7 Press the battery down into the socket until it snaps into place.
Make sure that the battery is securely installed in the socket.
8 Reassemble the system and verify its functionality (see
9 Configure the time and date in Setup (see Configuration and Setup, which is part of the user
documentation set).
Failure to configure the time and date will cause the ColorPASS to hang when user software is
being installed on the ColorPASS. (See
Clearing the CMOS
Clear the CMOS after installing a new motherboard, CPU, DIMM, or DVD drive to ensure
compatibility between the new component and previous settings stored in the BIOS.
T
CMOS
O CLEAR THE
1 Shut down, and then open the ColorPASS (see pages
Make sure to remove the copier interface cable from the power outlet before opening the
ColorPASS and clearing the CMOS.
2 Remove the battery (see
3 Wait two minutes to allow the motherboard electrical components to fully discharge.
4 Reinstall the battery (see
5 Reassemble the ColorPASS and verify its functionality (see
6 Reset the time and date in Setup (see Configuration and Setup, which is part of the user
documentation set).
Failure to configure the time and date will cause the ColorPASS to hang when user software is
being installed on the ColorPASS (see
page
127.)
page
82).
page
82).
page
127).
page
103).
page 48
and
page
51).
page
103).
83
Advertisement
Table of Contents
