Table of Contents
Advertisement
S
P
ERVICE
ROCEDURES
T
O REMOVE BOARDS AND CABLES FROM THE MOTHERBOARD
1 Shut down and open the ColorPASS (see pages
To access the motherboard, you must remove the left side panel.
2 Remove all boards installed in slots on the motherboard.
Note the location of the slot where each board resides so that you can reinstall the board in
the same slot later.
3 Remove the following cables from the old motherboard:
First remove any plastic cable clamp(s) securing internal cables and reusable tie-wraps,
N
:
OTE
if present.
• Front panel fan cable (FAN 4)
• Reset button cable (JP4)
• Power button cable (JP4)
• Speaker cable (JP5)
• UIB cable (USB3)
• Front panel USB port cables (USB2 and USB4)
• DVD drive cables:
– SATA data cable from motherboard connector SATA 0
– Power and data combination cable from the back of the DVD drive
• Hard disk drive cables:
– SATA data cable from motherboard connector SATA 1
– Power supply cable from the back of the hard disk drive
• Motherboard power cable (20-pin, PW2)
• CPU power cable (8-pin, PW1)
For motherboard connector locations, see
48
and 51).
Figure 21 on page
61.
62
Advertisement
Table of Contents
