Table of Contents
Advertisement
I
NSTALLATION
Installation sequence
I
NSTALLATION
This chapter includes information about the following:
• Installation sequence (see the following section)
• Checking the customer site (see
• Unpacking the ColorPASS (see
• Installing the ColorPASS and connecting it to the copier and the network (see
• Completing the installation (see
– Print a Test Page and a Configuration page.
– Remind the site administrator to install the current user software on networked
computers that print to the ColorPASS (see Printing and Utilities, which is part of the
user documentation set.
Familiarize yourself with this chapter before you attempt an installation. The installation
sequence described in this chapter is designed to make your job as easy as possible. Installation
problems are easier to avoid and diagnose if you proceed from the component to the system
level and verify functionality at each stage.
installation procedure for connecting the ColorPASS to the copier.
Because the ColorPASS is a node on the customer's computer network, make sure that you
coordinate your scheduled installation with the network administrator at the customer site.
For Network Setup information, refer the network administrator to Configuration and Setup,
which is part of the user documentation set.
You can change the default language that is preinstalled at the factory using the
N
:
OTE
Configure tool available through Command WorkStation and WebTools. Start Configure,
choose Server > General > Choose Server Language, and then click Apply. It takes up to three
minutes to change languages.
page
24)
page
26)
page
31)
Figure 3 on page 23
22
page
28)
outlines the recommended
Advertisement
Table of Contents
