Canon ColorPASS-GX400 Installation And Service Manual page 75

Hide thumbs Also See for ColorPASS-GX400:

Table of Contents

ERVICE

ROCEDURES

7 If a monitor is connected to the ColorPASS:

• When the Log On to Windows dialog box appears on the monitor, type Fiery.1 in the

password field, and then press Enter on the keyboard.

Type Fiery.1 exactly as shown. The password is case-sensitive; for example,

OTE

fiery.1

will not work.

• Wait for Idle to display on FieryBar on the monitor.

If the ColorPASS is not connected to the copier, or if the copier is not powered on, a

message displays indicating the status. Expect this message. The ColorPASS detects the

copier after you connect the ColorPASS to the copier.

8 Reattach any dongle(s) (for example, for SeeQuence Compose or Impose) or USB storage

device(s) you may have removed previously.

Error messages

One of the following error messages may display on the ColorPASS Control Panel or monitor

when you attempt to transfer options to the new motherboard.

Could not mount the dos/boot partition:

Feature Update CD. The Feature Update CD is not supported by the ColorPASS. Obtain the

Fiery Options Utility DVD and try the procedure again.

Invalid dongle found! Please remove dongle and connect the correct dongle:

dongle is not supported by the Fiery Options Utility. The dongle may have been attached by

mistake. Obtain a valid dongle and try again.

More than one dongle found. Remove all dongles except the correct dongle:

Fiery Options Utility will not work when more than one dongle is attached to the system.

The dongle has already been used and cannot be reused. Obtain an

No uses remaining:

unused dongle and start again.

Check power and video cable connections:

the ColorPASS and the copier. Make sure that the interface cables are properly connected and

the copier is on and ready to print.

• If an error condition cannot be corrected, restore the previous hardware configuration, if

possible, and contact your authorized service/support center.

You have attempted to transfer options using the

There is a problem with the connection between

The attached

The

Table of Contents