Table of Contents
Advertisement
I
NSTALLATION
Checking the customer site
Before you install the ColorPASS, check site conditions and inform the customer of any
installation requirements.
Copier readiness
Is the copier configured for use with the ColorPASS? (For the proper settings, see the
documentation that accompanies the copier.)
Is space available near the copier for the ColorPASS?
Make sure that adequate space is available for the ColorPASS. Allow enough space at the back
panel for the cables to route easily and at the side panel so that the ColorPASS does not
interfere with use of or service to the copier (such as clearing a paper jam). You may need to
move the copier away from the wall so that the interface connectors are accessible.
20cm+ (8 in.)
20cm+ (8 in.)
Does the copier require service or adjustments?
Print the copier Test Page before you install the ColorPASS.
If the image indicates that the copier needs adjustment, inform the customer. After getting
approval, complete the necessary copier service.
Power
Is a dedicated, grounded electrical outlet for the ColorPASS available near the copier?
Locate the grounded electrical outlet that will supply power to the ColorPASS. Do not run
the ColorPASS and the copier on the same circuit. If the customer has provided one, use a
surge suppressor for the ColorPASS.
• Do not use a 3-prong adapter in a 2-hole, ungrounded outlet.
• Do not use an extension cord.
• Do not plug the ColorPASS into a circuit with heating or refrigeration equipment
(including water coolers).
• Do not plug the ColorPASS into a switchable power outlet. This can result in the
ColorPASS being turned off accidentally.
• Do not pull on the cable when unplugging the ColorPASS. Instead, pull the plug.
Back panel
ColorPASS
Side panel
24
Advertisement
Table of Contents
