EverFocus EMV1200 FHD User Manual page 85

SD Backup: Check the box to enable Alarm event backup recordings to the SD card. When an
alarm is triggered, the mobile DVR will record the alarm event to the SD card for 60 seconds
start from the triggered time. The SD card will start recording the next alarm event only when
the recording process is done (the alarm events occurred during the SD card recording
process will be ignored and not be recorded). Up to four alarm events can be simultaneously
recorded if the alarms are triggered at the same time.
FTP Upload: Check the box to enable uploading recordings to the FTP server function. To
setup the FTP server, please refer to 6.6.6 FTP.
Note:
1. If the Archiving Recording to the FTP server function (refer to 4.7 Archiving the
Recordings to the USB or FTP) is working in progress, the FTP Upload function will stop.
The system will start the FTP Upload function when the Archiving Recording to the FTP
progress is complete.
2. If multiple alarms have been triggered, up to 10 alarm recordings can be simultaneously
uploaded to the FTP server at once.
Panic Alarm: Check the box to send panic alarm data to the Xfleet system.
Send to Xfleet: Check the box to send the alarm data to the Xfleet system. Note that for the
Xfleet system to receive alarm data from the mobile DVR in order to perform the alarm event
actions on Xfleet system, this function must be enabled.
FTP Upload File Type: Select MP4 file type to upload videos to FTP server; select JPEG file
type to upload snapshots to the FTP server.
Alarm Output: Select an alarm output number. When an alarm is triggered, the signal will be
transmitted through the selected alarm output relay.
Output Type: Select an output type when an alarm is triggered.
Timeout: Select this option and then set up the Timeout Duration in the field below, the
alarm output will last for the setup duration time (1 ~ 150 seconds).
Permanent: Alarm will remain active until the user presses the "Enter" key on the IR
Remote Control or resets the alarm remotely.
Transparent: Alarm output remains as long as the alarm input is active.
Trans + Timeout: Alarm output continues until event ends, then continues for the setup
duration time (1 ~ 150 seconds).
Timeout Duration: This function only appears when you select Timeout or Trans + Timeout
options in the Output Type drop-down list. Select a duration time for the event. The alarm
output will last for the setup duration time between 1 and 150 seconds.
Main Monitor/Call Monitor: Select Full Screen to force the camera associated with the
selected alarm number to display full screen on the monitor. The full screen camera view will
last according to the Output Type selected in the field above.
Record: Select a camera to start recording when the associated alarm number is triggered.
Input Type: Select an input type when the selected alarm number is triggered. The options
include N.O. and N.C.
Active Camera: This function is for associating an alarm trigger with a specific camera. For
example, if you set up an external alarm detector near Camera 2, you can select Camera 2 in
EMV1200 FHD / EMV800 FHD Hybrid Mobile DVR
75