EverFocus EMV1200 FHD User Manual page 16

System LEDs
8
Call Monitor
9
(RCA)
10 Audio Out
Ethernet Port
11
(WAN)
• Alarm: Turns on when the connected alarm I/O is triggered; turns off
when the alarm I/O stops being triggered.
• GPS: Turns on continuously when the mobile DVR is receiving GPS
data.
• System Fail: Turns off when system is acting normally. Turns on when
these events occur: System Clock Error / Fan Fail / Disk Temperature
Over / Disk Fail / Disk Off / Network Loss.
• Heater: Blinks when heater on; off blinking when heater off.
• HD R/W: Blinks when the HDD is reading or writing.
• Power: Turns on continuously when the power is supplied. Blinks
when Battery power error occurs (lower than 9V or higher than 36V)
or 12VDC power supply error.
By default, this port is set to a Call monitor output. Connects to a Call
monitor using a RCA cable.
Note: You can optionally switch this port from Call monitor to Main
monitor. Please refer to 2.6 Monitor Connection for more details.
RCA audio output for connecting to the speakers. The audio output only
works during playback. Speakers with a (built-in) amplifier and external
power supply are required.
One RJ-45 port for connecting to the network.
EMV1200 FHD / EMV800 FHD Hybrid Mobile DVR
6